# # $Id:$ # # # Configuration file for natd. # # # Enable logging to file /var/log/alias.log # log no # # Incoming connections. Should NEVER be set to "yes" if redirect_port, # redirect_address, or permanent_link statements are activated in this file! # # Setting to yes provides additional anti-crack protection # deny_incoming no # # Use sockets to avoid port clashes. Uses additional system resources, but # guarantees successful connections when port numbers conflict # use_sockets no # # Avoid port changes if possible when altering outbound packets. Makes rlogin # work in most cases. # same_port yes # # Verbose mode. Enables dumping of packets and disables # forking to background. Only set to yes for debugging. # verbose no # # Divert port. Can be a name in /etc/services or numeric value. # port 32000 # # Interface name or address being aliased. Either one, # not both is required. # # Obtain interface name from the command output of "ifconfig -a" # # alias_address 192.168.0.1 interface ep0 # # Alias unregistered addresses or all addresses. Set this to yes if # the inside network is all RFC1918 addresses. # unregistered_only no # # Configure permanent links. If you use host names instead # of addresses here, be sure that name server works BEFORE # natd is up - this is usually not the case. So either use # numeric addresses or hosts that are in /etc/hosts. # # Note: Current versions of FreeBSD all call /etc/rc.firewall # BEFORE running named, so if the DNS server and NAT are on the same # machine, the nameserver won't be up if natd is called from /etc/rc.firewall # # Map connections coming to port 30000 to telnet in my_private_host. # Remember to allow the connection /etc/rc.firewall also. # # The following permanent_link and redirect_port statements are equivalent #permanent_link tcp my_private_host:telnet 0.0.0.0:0 30000 #redirect_port tcp my_private_host:telnet 30000 # # Map connections coming from host.xyz.com to port 30001 to # telnet in another_host. #permanent_link tcp another_host:telnet host.xyz.com:0 30001 # # Static NAT address mapping: # # ipconfig must apply any legal IP numbers that inside hosts # will be known by to the outside interface. These are sometimes known as # virtual IP numbers. It's suggested to use the "interface" directive # instead of the "alias_address" directive to make it more clear what is # going on. (although both will work) # # DNS in this situation can get hairy. For example, an inside host # named aweb.company.com is located at 192.168.1.56, and needs to be # accessible through a legal IP number like 198.105.232.1. If both # 192.168.1.56 and 198.105.232.1 are set up as address records in the DNS # for aweb.company.com, then external hosts attempting to access # aweb.company.com may use address 192.168.1.56 which is inaccessible to them. # # The obvious solution is to use only a single address for the name, the # outside address. However, this creates needless traffic through the # NAT, because inside hosts will go through the NAT to get to the legal # number, even when the inside number is on the same subnet as they are! # # It's probably not a good idea to use DNS names in redirect_address statements # #The following mapping points outside address 198.105.232.1 to 192.168.1.56 #redirect_address 192.168.1.56 198.105.232.1