# $FreeBSD$

PROG?=	boot0
STRIP=
BINMODE=${NOBINMODE}
NO_MAN=
SRCS=	${PROG}.S

# The default set of flags compiled into boot0.  This enables update (writing
# the modified boot0 back to disk after running so that the selection made is
# saved), packet mode (detect and use the BIOS EDD extensions if we try to
# boot past the 1024 cylinder liimt), and booting from all valid slices.
BOOT_BOOT0_FLAGS?=	0x8f

# The number of timer ticks to wait for a keypress before assuming the default
# selection.  Since there are 18.2 ticks per second, the default value of
# 0xb6 (182d) corresponds to 10 seconds.
BOOT_BOOT0_TICKS?=	0xb6

# The base address that we the boot0 code to to run it.  Don't change this
# unless you are glutton for punishment.
BOOT_BOOT0_ORG?=	0x600

# Comm settings for boot0sio.
# Bit(s) Description
# 7-5    data rate (110,150,300,600,1200,2400,4800,9600 bps)
# 4-3    parity (00 or 10 = none, 01 = odd, 11 = even)
# 2      stop bits (set = 2, clear = 1)
# 1-0    data bits (00 = 5, 01 = 6, 10 = 7, 11 = 8)
.if !defined(BOOT_BOOT0_COMCONSOLE_SPEED)
BOOT_COMCONSOLE_SPEED?=	9600
.if ${BOOT_COMCONSOLE_SPEED} == 9600
BOOT_BOOT0_COMCONSOLE_SPEED=	"7 << 5 + 3"
.elif ${BOOT_COMCONSOLE_SPEED} == 4800
BOOT_BOOT0_COMCONSOLE_SPEED=	"6 << 5 + 3"
.elif ${BOOT_COMCONSOLE_SPEED} == 2400
BOOT_BOOT0_COMCONSOLE_SPEED=	"5 << 5 + 3"
.elif ${BOOT_COMCONSOLE_SPEED} == 1200
BOOT_BOOT0_COMCONSOLE_SPEED=	"4 << 5 + 3"
.elif ${BOOT_COMCONSOLE_SPEED} == 600
BOOT_BOOT0_COMCONSOLE_SPEED=	"3 << 5 + 3"
.elif ${BOOT_COMCONSOLE_SPEED} == 300
BOOT_BOOT0_COMCONSOLE_SPEED=	"2 << 5 + 3"
.elif ${BOOT_COMCONSOLE_SPEED} == 150
BOOT_BOOT0_COMCONSOLE_SPEED=	"1 << 5 + 3"
.elif ${BOOT_COMCONSOLE_SPEED} == 110
BOOT_BOOT0_COMCONSOLE_SPEED=	"0 << 5 + 3"
.else
BOOT_BOOT0_COMCONSOLE_SPEED=	"7 << 5 + 3"
.endif
.endif

CFLAGS+=-DFLAGS=${BOOT_BOOT0_FLAGS} \
	-DTICKS=${BOOT_BOOT0_TICKS} \
	-DCOMSPEED=${BOOT_BOOT0_COMCONSOLE_SPEED}

LDFLAGS=-N -e start -Ttext ${BOOT_BOOT0_ORG} -Wl,-S,--oformat,binary

.include <bsd.prog.mk>