#
# Specific board setup for the Atheros AP96 reference board.
#
# The AP96 has the following hardware:
#
# + AR7161 CPU SoC
# + AR9223 2.4GHz 11n
# + AR9220 5GHz 11n
# + AR8316 10/100/1000 switch
# + m25p64 based 8MB flash
# + 64mb RAM
# + uboot environment

# $FreeBSD$

include		"AR71XX_BASE"
ident		"AP96"
hints		"AP96.hints"

options		AR71XX_REALMEM=64*1024*1024

options		AR71XX_ENV_UBOOT

# For DOS - enable if required
options 	GEOM_PART_BSD
options 	GEOM_PART_MBR
options 	MSDOSFS

# uncompress - to boot read-only lzma natively from flash
device		geom_uzip
options 	GEOM_UZIP

# Used for the static uboot partition map
device          geom_map

# Boot off of the rootfs, as defined in the geom_map setup.
options         ROOTDEVNAME=\"ufs:map/rootfs.uzip\"

# Options needed for the EEPROM based calibration/PCI configuration data.
options 	AR71XX_ATH_EEPROM	# Fetch EEPROM/PCI config from flash
options 	ATH_EEPROM_FIRMWARE	# Use EEPROM from flash
device		firmware		# Used by the above

# Options required for miiproxy and mdiobus
options 	ARGE_MDIO		# Export an MDIO bus separate from arge
device		miiproxy		# MDIO bus <-> MII PHY rendezvous

device		etherswitch
device		arswitch